<-- nev left start -->

Vertical Clamping Horizontal Injection Machine

Vertical Clamping Horizontal Injection Machine
Vertical Clamping Horizontal Injection Machine
Product Description

Standard Features:

  • The hydraulic system operates with an energy saving regulating pump & proportional valve for drive & pressure regulation.
  • Centrally applied high performance hydraulic mould clamping cylinder
  • Linear transducer for clamping stroke with 1 mm accuracy.
  • Mould closing & opening speed profiles, 4 stages programmable.
  • Programmable closing & opening force.
  • Intermediate stop possible with closing & opening.
  • Monitoring of mould protection time.
  • Hydraulic mould protection regulated.
    • After alarm Mould Protection mould can either be stopped or opened.
  • Hydraulic Ejector, Forces, Speeds, Advancement & Retraction delay as well as stroke count (up to 5) programmable.
  • Modular injection unit as complete assembly group.
  • Injection unit equipped with linear transducer of 1 mm accuracy.
  • Four tie-bar type centrally fitted injection unit, vertical.
  • Continuous nozzle contact during the complete cycle.
  • Regulated injection speed profile, 5 steps programmable with injection delay.
  • Measurement, display and monitoring of injection time.
  • Switch over to holding pressure as a volume or time dependent function.
  • Material cushioning monitoring.
  • Screw circumferential speed display.
  • Open nozzle with screw in tip.
  • Electronically regulated cylinder and nozzle heating.
  • Monitoring of oil temperature & filter contamination.
  • Fine mesh oil filter in the return line.
  • Temperature regulator with digital temperature input, integrated in the PLC.
  • Temperature monitoring with tolerance band input regulation mode.
  • Corrosion proof stainless steel material hopper with emptying position.
  • Alarm for hopper emptying.

Regulated Parameters:

  • Control Cabinet Temperature
  • Hydraulic Oil Temperature
  • Plasticizing Cylinder Temperature
  • Screw RPM
  • Screw Position
  • Nozzle Contact Force
  • Holding Pressure
  • Back Pressure
  • Movements and force of mould and ejector
  • Ramp control sequence for mould and ejector end position
Contact Us

Road No. 4, Plot No. 22, Kathwada G. I. D. C., Odhav, Ahmedabad, Gujarat, 382415, India
Phone :+918037401815